RapidVap N2
Nitrogen Evaporator
DESCRIPTION
The RapidVap N₂ Evaporation Systems provide a fast, automated alternative to Kuderna-Danish and rotary evaporators, compatible with a wide range of aggressive chemicals. By directing a controlled stream of nitrogen or dry gas onto the sample surface, these systems reduce the partial pressure above the liquid to accelerate evaporation, with optional vortex motion and dry heat for further speed. The main block accommodates eight large samples up to 450 mL each, and an accessory block supports eight 170 mL tubes for solid phase extraction. The unique Cool-Zone block design slows evaporation after the end point, preventing samples from going completely dry and allowing time for solvent exchange or removal. Built-in alarms notify users when the process reaches the timed end point or approaches completion, enabling unattended operation.
In partnership with Labconco.
Dry Block
Dry heating system prevents potential contamination source
Increased Surface Area
Vortex motion increases surface area for faster evaporation
PTFE-Coated Chamber
Aluminum with PTFE coating for broad range of chemical compatibility
End-Point Detection
Signal completion of run allows samples to be left unattended while drying to desired end point
STANDARD FEATURES
- Dry block heating system prevents adding potential contamination source
- Vortex action, heat, and vacuum combine to accelerate evaporation
- PTFE-coated chamber for broad range of chemical compatibility
- Microprocessor-controlled vortex motion increases surface area for faster evaporation
- Signal completion of run allows samples to be left unattended while evaporation to desired end point
- Microprocessor-controlled nitrogen blow down manifold to facilitate liquid to gas phase change
REQUIREMENTS (not included):
- Glassware
- Nitrogen source with flow rate of 0.6 CFM/17 LPM minimum
- Gas pressure regulator
OPTIONS:
- RS-232 Link for two-way communication (Cat# LC-7910010)
SPECS
| Instrument | RapidVap N2 |
| Instrument Catalog Number | LC-7910000 |
| Bath Type | Dry aluminum blocks |
| Number of Sample Positions | Up to 8 |
| Dimensions (w x d x h) | 21.7 x 19.0 x 13.5 in |
| Weight | Net: 99 lbs. (45 kg) Gross: 107 lbs. (49 kg) |
| Sample Layout | Circular |
| Lid Material | Glass |
| Pressure Regulator | 0-20 psi |
| Temperature Range | 0-100 °C |
| Warranty | 1 year |
| Electrical Requirements | 115V, 60 Hz |
| Vortex Motion | Up to 500 RPM |
| Nitrogen Requirements | |
| Flow Rate |
0.6 CFM / 17 LPM minimum |
| Pressure | 5-10 psi |
ACCESSORIES
- PTFE-coated aluminum blocks
- Borosilicate glass tubes
- 600 mL tubes with stems
- 170 mL tubes with stems
- Flat bottom tubes
- Eight-place stainless steel racks
- Glassware caps
GET QUOTE